Turbo kit Fiat Coupe 20v Turbo up to 450 hp GT3082HF + exhaust manifold + WG up to 450 hp
Item no: 420195
Package contents:
1x metal gasket for T3 flange 2x metal gaskets for 38 mm wastegate 1x gasket for T3 oil return/T4 1x high-pressure wide-band clamp 116–104 mm for 102 mm silicone 1x V-band clamp 63.5 mm V2A 1x 38 mm aluminum wastegate, CNC-machined, with accessories 0.4 bar 1x M12 ring eye to D04 1x HD wide-band Clamp 71–63 mm for 60 mm silicone 1x silicone vacuum hose, 6 mm diameter, length 1x metal gasket for Y-pipe flange T3/T4, GT30, GT35 5-hole 1x turbocharger GTR-525 HF (GT3082, GT30/40 ) 70A/R 360° racing bearings 5x stud bolts M10x40 1x straight silicone reducer 102x60mm 4x stud bolts M8x35 1x adapter for oil supply to T3/T4 + GT30 + GT35 plain bearing 3mm 1x oil supply line, 40 cm, with D04 connectors 5x M10 copper nuts made of copper with 17 mm wrench size 4x M8 copper nuts made of copper with 13 mm wrench size 1x turbo manifold Fiat Coupe 20v Turbo 20vT T3 + 38mm WG connection 1x 45° adapter 1/2 NPT > 15mm hose connection 1x elbow is delivered in separate parts for self-welding. Photo is only an example
We adapt the turbo for you so that it can be installed in the vehicle. Due to the limited space in the engine compartment, it may still be necessary to adjust the turbo on the vehicle yourself. To do this, simply loosen the screws on the retaining plates of the turbo and rotate the turbo into its final position. Then tighten the screws again.
Technical data turbocharger:
- Compressor housing outer A/R 70 High Flow
- Compressor wheel 82>61.4mm
- Turbine housing 63 A/R
- 360° racing bearings
- T3 flange (hole dimensions measured at center: 86x45mm)
- oil-cooled
- water-cooled
- Shaft is finely balanced
- up to approx. 2 bar
suitable for:
- all Fiat Coupe/Marea/Bravo 20vt Turbo 5-cylinder vehicles, including vehicles with air conditioning.
To achieve an output of approx. 450 hp, larger injectors such as 440ccm, a 255L/hr fuel pump are also required and the software (chip) must be adjusted. In addition, reinforced pistons + connecting rods should be installed.
